Stainless steel soft joint sealing surface wear and thickness changes (normal wear is generally 5-10 mm); Sealing surface friction track, to see if there are three fracture or scratches. If there is any situation, should be replaced immediately. Usually in the process of assembly, hydraulic stainless steel soft joint leak is due to the operation is not standard, stainless steel section soft joint rotor concentricity, cooperate with the low degree of connection part, caused by vibration.
The sealing surface of the stainless steel flexible connectors due to small particles such as dust or dirt into hydraulic stainless steel flexible connectors and damage; In theory, the stainless steel flexible connectors is not 38 tube fitting easy to rust. We need to check the corresponding spindle head and stainless steel soft joint parts size and degree, and appropriate adjustments and stainless steel soft joint connection of rotor parts. If the fault still exists, the need to determine whether there is a need to repair equipment shaft head. Of course, if it is stainless steel flexible connectors, will need to replace stainless steel flexible connectors.
Stainless steel soft joint secret is adding some carbon steel metal chrome, its composition is not low. At about 12%, he contact with the gas will produce chrome and co2, it is embodied in carbon steel surface passivation membrane with high density, the stainless steel pipe fittings properly continue maintenance. And the passivation film is very thin, you can see on the surface of the stainless steel flexible connectors luster, make the surface of the stainless steel flexible connectors with some very distinct characteristics. But in order to ensure that the protective film is not destroyed, once destroyed, exposed steel can react with co2 directly, can affect the process of passivation film, reinstall the pillar.
About hydraulic transition joints, probably a lot of people do not know much about it, but used it know, compared with other pipe connector, the advantages of hydraulic transition joints is obvious, so now the vast majority of people in choosing a joint, or choose more.
Hydraulic joint hydraulic transition joint and other joints have a significant difference is that the material is different, the other joint type or more commonly used material, but the hydraulic transition joint materials are generally made of metal material and copper. It is because of the strength of the material selection are generally stainless steel plate and copper, so the characteristics of its high Z is compressive capacity is very large. As long as the compressive performance is strong enough, then the seam is durable enough, using standard nature also more widely.
In hydraulic system software, the hydraulic transition joints are generally transition joints, sudden rupture due to hydraulic pipeline, the oil of the visual impact is very big also, therefore, is also high to the requirement of itself, so the hydraulic transition joint itself is needed. And in the assembly process is very convenient.
Because it is the essence of the two have differences in the middle of the joint to have another transition in, although the joint is hydraulic, but is also easy to assemble on the side. Some joint, such as hydraulic transition joints, etc., in brass tube fitting some parts adopt "pressure" ring or diameter of seal leakage, leakage of its root cause is "pressure" ring of embrittlement or deformation caused by leakage; Adopted the "pressure" rings "pressure" ring, "pressure" type seal leakage caused by "pressure" form; "Pressure" in areas such as the ring leak; "Pressure" ring joints, such as the leakage; "Pressure" ring joint leakage;